Scroll through the list of available services until you find one labeled "Remote Access Service". Click on it to highlight it, as shown above. Click the OK button, and Windows NT will install that service. You'll be prompted for your installation CD-ROM if RAS has not been previously loaded.

Click on the Start Button, then Programs, then Accessories, then Dial-Up Networking. You should see the following screen. Click the New button.

The New Phonebook Entry window should now appear.Entry name and correct Phone number should be entered. Verify that the correct modem is listed in Dial using: When done, click the Server tab.

Server settings should be as displayed below. When done, click the TCP/IP settings button.

Click Specify Name Server Addresses and enter the numbers for the Primary(206.27.119.251) and Secondary(206.27.119.252) DNS. Make sure to turn off Use IP Header compression. When done, click O.K.>

Click the Script tab and simply click None Click the Before Dialing button.

Set Before Dialing Script to None. Click O.K.

Click the Security tab and set to Accept any authentication. Click O.K.

The Dial-Up Networking screen will now appear with the Wizard profile ready to go. Click Dial if all goes well you should connect to Wizard